WINGS AND WHEELS Soaring Supplies
2049 Shadyside Road
Lakewood, NY 14750
Telephone (716)763-3213 Fax (716)763-3214
email: tim@wingsandwheels.com

Voltage is important because the voltage of the battery must match the application requirements of the device. Voltage is simply a unit of measuring electrical pressure, and all batteries are rated in volts DC (Direct Current). Think of water flowing down a river. Voltage is how quick that water is flowing, where as amperage is the amount of water flowing. The more voltage the stronger the flow of the water. The more amperage, the more water flowing.

Excellent Quality and Economy priced Batteries for 12 and 14 volt applications

Build a higher voltage high capacity 14 Volt battery pack
especially suited for older radios that typically work better at higher voltages
(2) PS4100 4 Volt 10 Amp Hr. + (1) PS-6100 6 Volt 10aH
or
(1) PS-1272 12V 7.2 aH + (1) PS-260  2 Volt 6aH

2 Volt

PS-260 1.97" x 1.34" x 3.94" (0.86 lbs.) 2 Volt 6aH...$24.95

4 Volt


PS-4100 10 Amp Hr. 4.02"x1.97"x3.72" (3.1lbs) ......$27.55

6 Volt

    
PS-670 5.95" x 1.34" x 3.70"(2.80 lbs.) 6Volt 7aH.....$25.50
PS-6100 5.95"x2.00"x3.70" (4.6lbs) 6 Volt 10aH.......$28.95

12 Volt
PS-1229


 7.01"x 1.34"x 2.60" (2.10 lbs) 12V 2.9aH...$34.00
(The PS1229 are typical of many sailplane tail batteries)

NEW HIGH-RATE BATTERIES
More Amp Hours in the same size package
PS-1272 F1 and  PS-1290 F2

12 Volt 7.2 Amp. Hrs.
Features: Absorbent Glass Mat (AGM) technology for superior performance. Valve regulated, spill proof construction allows safe operation in any position. Power/volume ratio yielding unrivaled energy density. Rugged plastic case and cover Approved for transport by air. D.O.T., I.A.T.A., F.A.A. and C.A.B. certified. U.L. recognized under file number MH 20845. 5.95" x 2.56" wide x 3.70" high (3.86 over terminals and 6.10 pounds
$34.95
12 Volt 9.0 Amp. Hrs.
Features: Absorbent Glass Mat (AGM) technology for superior performance. Valve regulated, spill proof construction allows safe operation in any position. Power/volume ratio yielding unrivaled energy density. Rugged plastic case and cover Approved for transport by air. D.O.T., I.A.T.A., F.A.A. and C.A.B. certified. U.L. recognized under file number MH 20845. 5.95" x 2.56" wide x 3.70" high (3.86 over terminals and 6.10 pounds
$39.95

PS-1282S 8.0 Amp Hr.
 

3.86"x 4.40"x 4.65"(6.7 lbs)
(The PS-1282S fits quite nicely in the Libelle Battery box)
 $54.95

PSH-12100 12 Volt 10.5 Amp. Hrs.
5.95"L x 4.37"* H x 2.56" W *4.61" over terminals 7.00 lbs. (3.18 kg)
designed specifically for applications such as uninterruptible power supplies where short duration high-rate discharge currents are required. The PSH12100 has the same footprint as the PSH-1280, but with the extra height pushes the capacity envelope to an amazing 10.5AH! Features: Absorbent Glass Mat (AGM) technology for superior performance. Designed specifically for high-rate discharge (UPS) applications.  41 Watts/cell for 15 min. of constant power Rugged plastic case and cover. Approved for transport by air. D.O.T., I.A.T.A., F.A.A. and C.A.B. certified. U.L. recognized under file number MH 20845.
$49.95

PS-12100F2 12 Volt 12.0 Amp. Hrs.
PowerSonic PS12100F2, 12V, 12.0Ah, Sealed Lead-Acid Battery, Maintenance-free, Terminal Type: F2, Quick Disconnect Tabs, Mates with AMP. Inc. Faston "250" Series, Length 6.0", Width 4.4", Height 3.7", Wt-9.2 lbs.
$52.95


PS12140 12 Volt 14.0 Amp Hrs
L: 5.95 (151) W: 3.86 (98) H: 3.70 (94) HT: 3.94 (100)
$59.00

NOTE: These are ALL Non-Spillable, Re-Chargeable Sealed-Lead Acid Batteries. The term GEL-CELL is frequently, but improperly used to describe this type battery.
CHARGING: Cycle Applications: Limit initial current to 2.16A. Charge until battery voltage (under charge) reaches 14.40 to 14.70 volts at 68oF (20oC). Hold at 14.40 to 14.70 volts until current drops to approximately 72mA. Battery is fully charged under these conditions, and charger should either be disconnected or switched to “float” voltage.
“Float” or “Stand-By” Service: Hold battery across constant voltage source of 13.50 to 13.80 volts continuously. When held at this voltage, the battery will seek its own current level and maintain itself in a fully charged condition.
NOTE: Due to the self-discharge characteristics of this type of battery, it is imperative that they be charged after 6-9 months of storage, otherwise permanent loss of capacity might occur as a result of sulfation.
We highly recommend the R&R chargers and have used this type here for years, R&R Chargers are designed for just this purpose and battery type. With this type charger and proper charging practices these batteries give years or dependable service and maintain high capacity.

Walter Dittel battery box

Similar to Filser battery box but made of stronger Stainless Steel and high grade powder coated steel construction complete with voltmeter and DIN Connector outlet socket and one mating DIN connector plug *, Voltmeter with PTT (push to test) button and circuit breaker. Battery is NOT included but accepts most common 12 volt batteries of 6.5 -8.0 Amp hr. like Powersonic batteries listed above or commonly available batteries from many manufacturers.
$266.00
DIN Connectors available $14.00 each

Battery Chargers on following page

24
Browse the catalog
Back to Index